Help with wire harness cb350

Hi guys....I took a break from the project but I've been messing with it again.
It their a way that I can test this switch for the brake lights.
Thanks
 

Attachments

  • image.jpeg
    image.jpeg
    1 MB · Views: 235
Use a multimeter to check continuity between the two wires. You should get a reading pretty close to zero Ohms when the switch is activated.
 
The switch simply connects the 2 wires when it is pulled, so you can unplug it and use a test light to check it.


They're as simple as it gets - might be incorrectly adjusted or dirty inside if it doesn't work.
 
Thanks Hillsy
Just did a little experiment to test it and it doesn't seem to work. So I'll try to adjust it or clean it..
Thanks
 
Well ... I justed finish adjusting the switch and for my luck neither brake switch work.
So if anybody can direct me where can I purchase them I'll appreciate it
Thanks
 
Checked out eBay and ordered the parts and I got them on Saturday .
I got my parts from Classiccycleparts and they ship quick.
Will be installing during the week and I'll get back with the results .
Thanks
 

Attachments

  • image.jpeg
    image.jpeg
    1.7 MB · Views: 221
Hi Guys after almost 2 years, I finally started working back on this project.
Should by riding it for this summer...
thanks
 

Attachments

  • 20190117_154333.jpg
    20190117_154333.jpg
    3.8 MB · Views: 189
You must log in or register to reply here.

DTT Light or Dark

  • DTT Light
    • www.jadusmotorcycleparts.com
    www.lostapostle.ca/
    www.sparckmoto.com

    Spread the Love

    Back
    Top Bottom