offroadjeepin
New Member
WOW. Looks awesome!
CB160 Gauge Pod
- Thread starter redwillissuperman
- Start date
work9to5
See you in the wind.
redwillissuperman
Keep it simple- engine, wheels, bars
Verified the fitment for the outside-in fitment:
Going to print a flat design next then off to limited production
Going to print a flat design next then off to limited production
offroadjeepin
New Member
Looks great. How is the Vapor held in?
redwillissuperman
Keep it simple- engine, wheels, bars
There is a bracket that bolts the Vapor into the backside.
redwillissuperman
Keep it simple- engine, wheels, bars
SONIC. said:
I have complete dominion to raise or lower the Vapor recess. There is a limit to the minimum material thickness of the flange but I could remove it and have the unit itself make the top surface. Not the look I was going for, but possible.
offroadjeepin
New Member
I'll take whatever i can get but i also would like to see it dropped in from the top.
redwillissuperman
Keep it simple- engine, wheels, bars
Low profile that drops into headlight bucket from top.
Will make a flat one too.
offroadjeepin
New Member
Any updates? haven't been on here in awhile. Hoping to get back to my build shortly.
offroadjeepin
New Member
Any thing new with these? My build has been on the back burner but still very interested in one of these!
