TripleKing
Been Around the Block
I am having an issue with the lights at the back of my 89 750 Katana. Without warning, my tail light and license late light died. When I apply the brake light, the tail light circuit would light Long story short, here is where I am now:
When I plug in the license plate light, it shorts the system. When I plug in an accessory light I have, or I use my test light, it works normally.
When I plug in my tail light/brake light, it shorts the system. When I plug in another dual filament light, it shorts out the system. When I plug in two separate lights to the brake light, tail light harness and have a single filament light, other than the factory light, plugged into the license plate light, the entire system works fine.
Why are dual filament lights shorting my tail light/ brake light, but separate single filaments are ok. Also, I jumped ground straight to negative on the battery and it makes no difference.
Non of this makes sense. It is totally illogical. Even the folks on the Katana board are stumped.
Please help me.
When I plug in the license plate light, it shorts the system. When I plug in an accessory light I have, or I use my test light, it works normally.
When I plug in my tail light/brake light, it shorts the system. When I plug in another dual filament light, it shorts out the system. When I plug in two separate lights to the brake light, tail light harness and have a single filament light, other than the factory light, plugged into the license plate light, the entire system works fine.
Why are dual filament lights shorting my tail light/ brake light, but separate single filaments are ok. Also, I jumped ground straight to negative on the battery and it makes no difference.
Non of this makes sense. It is totally illogical. Even the folks on the Katana board are stumped.
Please help me.