ManuR
Active Member
Hey guy's
I am coming to the point in my build that i have to get my brake cables.
I would like to run a single braided stainless steel cable setup so also without the bend hard tube at the end.
Does anybody know the exact thread type of the brake calliper?
I thought it was just an M10x1.25 thread? but i'd rather be shure
Thanks
I am coming to the point in my build that i have to get my brake cables.
I would like to run a single braided stainless steel cable setup so also without the bend hard tube at the end.
Does anybody know the exact thread type of the brake calliper?
I thought it was just an M10x1.25 thread? but i'd rather be shure
Thanks