I'm going to kill someone...Master Cylinder Quality (or lack thereof)

raptormeat

Been Around the Block
I spent good money ($70) on a master cylinder from MikesXS, the black one 10mm, I go to try and bleed it and its not bleeding, because the rubber seal that encapsulates the pushrod that the lever hits is leaking. So I go on eBay and get another one, different company...SAME FUCKIN THING.

What are you guys running? Where can I get one, preferably in black?
 
They were both for 7/8 handlebars, the MikesXS was for my CB360, the eBay one was for my RD350, both have disk brakes, obviously, and both have no master cylinders at the moment.
 
raptormeat said:
They were both for 7/8 handlebars, the MikesXS was for my CB360, the eBay one was for my RD350, both have disk brakes, obviously, and both have no master cylinders at the moment.

10mm is pretty small for a disc setup. Most people run a 11mm or 12mm setup.
 
I have no issues with nissin masters, cost was double what you paid but do it once do it right.
 
Why not contact MikeXS? They have pretty good customer service...
I'm sure they would have sent you whatever you needed
 
Back
Top Bottom