Hey guys!
I´m in the middle of searching for a faulty clutch on my XS 750 project (its a PIA, can´t find whats wrong with this thing).
When the bike is in 1st gear and I completely pull the clutch in it still rolls slightly forward,impossible to roll the bike backwards when fully clutched in,in 1 st gear....
So here´s the question:
How do you guys smoothen out clutch baskets wears like in the pic below?
Even though the clutch friction pads look good, I will change them out for new OEM plates to rule out this problem.
Do you guys use some scotch brite on the steel plates before reassembly?
THe friction plates will be soaked in oil for a day before reassembly.
Thanks in advance!
I´m in the middle of searching for a faulty clutch on my XS 750 project (its a PIA, can´t find whats wrong with this thing).
When the bike is in 1st gear and I completely pull the clutch in it still rolls slightly forward,impossible to roll the bike backwards when fully clutched in,in 1 st gear....
So here´s the question:
How do you guys smoothen out clutch baskets wears like in the pic below?
Even though the clutch friction pads look good, I will change them out for new OEM plates to rule out this problem.
Do you guys use some scotch brite on the steel plates before reassembly?
THe friction plates will be soaked in oil for a day before reassembly.
Thanks in advance!