Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
I'm investigating rear set possibilities for my little 81 Suzuki GS250. A problem I have run into is that the return spring for the brake is integral to and on the surface of the brake lever.
Anyone here fashion their own return spring? TIA
This is a good plan. Unless you are going to convert to a cable, or go with disc and hydraulic system, you should keep the existing crank arm and its position. You will see that the point where the crank attaches to the pull rod is nearly exactly the same on ALL drum brake bikes. The reason is the fact that the motion of the swingarm will push/pull on the pull rod if that pivot is even a small distance above or below its current location. Ideally, this point is coincident with the swing arm pivot, but slightly behind is ok as long as it is on the line between the pivot and the actuating crank arm pivot at the brake. This can make for a rather messy bunch of links and cranks if you want to keep the same pressure used to operate the brake, but the alternative is a more complete redesign.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.