Author Topic: loose bubble shield?  (Read 1127 times)

Offline jmhauck88

  • Posts: 1
loose bubble shield?
« on: Mar 13, 2013, 22:47:24 »
Anyone's bubble shield come loose? Mine has and I'm not sure if there is a good way to fix it. Any help would be appreciated!

Offline Rich Ard

  • *
  • *
  • Posts: 5772
  • doin' the backstroke in an estrogen ocean
Re: loose bubble shield?
« Reply #1 on: Mar 13, 2013, 22:57:35 »
Button it back on.
unplug the connectors from the harness and multimeter the shit out of them

Bad Points, a comic :: CB450 Restomod (sold) :: Viragostrosity :: GL1000 daily rider :: Kaw 175

Offline chillinfellow

  • Posts: 37
Re: loose bubble shield?
« Reply #2 on: Mar 14, 2013, 11:48:56 »
I use one, never a issue, usually a very slight amount of play from the snap button alignment slots, not sure why it would be so loose unless a button broke or its not snapped on properly ? maybe remove it and snap it back on ?
78 KZ400
02 EX500

Offline VonYinzer

  • *
  • Posts: 18384
Re: loose bubble shield?
« Reply #3 on: Mar 14, 2013, 12:31:07 »
Best way to fix it? Set it on your workbench or desk next to your laptop. Go to your favorite parts supply website. Order this (or something similar):


Like a river that don't know where it's flowin'
I took a wrong turn and just kept goin'

Offline brandonpx

  • Posts: 53
Re: loose bubble shield?
« Reply #4 on: May 03, 2013, 18:44:05 »
you can take a punch and hammer the center of each snap on the bubble shields snap rivets, will usually tighten it back down. mine does the same thing occasionally.