Post a pic of your latest purchase

[Sav0r]

Unfortunately my mill is R8 so I'd end up with additional costs, still probably a good deal but not necessarily a tool I need. I don't have enough horsepower to run a face mill much bigger than 2" (i have a 2.5" 90 degree that I really like, but I have to run really conservative feeds to keep from bogging my spindle). I have a 2" face mill that uses 10mm round inserts and actually came with 10 Mitsubishi inserts that I got used for $200, not only does it shred but those round inserts really last forever.

[J-Rod10]

[CrabsAndCylinders]

Wow!  You bought a fork lift. 

[seized79cb650]

Accidentally put an offer in on some PD carbs when it was really late. Like my grandmother who falls asleep to qvc and 2weeks later stuff shows up at her front door.

[WhyNot]

Wow!  You bought a fork lift. 

Or a new shop.

[J-Rod10]

Or a new shop.

Building one of those right now. In a few months, I'll have to move all this equiptment again.

[WhyNot]

Building one of those right now. In a few months, I'll have to move all this equiptment again.

Cool

[CrabsAndCylinders]

Cool

+1

[Tune-A-Fishİ]

Picked up a pair of redcap shop jackets off eBay for $20ea. Gonna ton em up complements of Beachcomber

[cxman]

a 1974 Sawakaki pig horn i needed another one

its very barn fresh been sitting since 84