Blood Sweat Tears and Grease > Trackers

First build CB360, any help will be great!!!!!!!!

<< < (14/14)

Moglix:
Yeah a friend said it may just be that needing adjustment, I only have the pull cable left so will look at adjusting that, thanks!!!!

trek97:

--- Quote from: trek97 on Jun 01, 2012, 07:30:51 ---might adjust air / fuel mix screws ?  If pipes kackle as you slow down and rpms dropping...its rich.  The reason you have to keep revs up.  to keep some air moving through there.   But if it hesitates on take off points to lean. 
And yes your bike is really good lookin.

--- End quote ---
I modified this to make it easier to read.

Moglix:
Cheers!!!!  ^^^^^ Also would have liked a the fender to follow round but it was a found/gifted rolled alloy one, we spared all we could to use...but I'm thinking about what to put there to help save wear and tear...

Sonreir:
Just a simple bit of sheet metal does the trick.  I fabbed this up and installed it in just under two hours.

stript.714 o/c:
Digging your bike man. i really like your seat!!!

Navigation

[0] Message Index

[*] Previous page