I got a few things in the mail today
Wires
RFID and relay
I pulled out all the boxes of parts I pulled off the bike when I was stripping it down and tried organizing a bit. There really wasn't much that was going back on the bike..
It was getting late too so I did a few small things while I was at it.
Adding new tank mounts, I chopped off the L mounts a while ago and used some all thead to make new ones.
Some washers and nuts, and some E mounts good as new.
A little electrical tape to hold the pucks on better. I would have used heat shrink tubing if I could find it...
My solo seat always seemed a bit long, and since I cut off the battery tray brackets I'm forced to relocate it... With the seat long there was no way to fit it under there, but if I took 4" off...
It took a while to get up the courage to Dremel it
Curved some to fit the tank
Not bad... It needs some sanding and smoothing but it fits well. And the tank/seat combo is solid as a rock.
I swapped to my extra 650 tank btw, the red one is straight and I don't want to risk banging it up if I don't have to.