Slipstream Cycle

DWMS Racing


Author Topic: Table Jack  (Read 644 times)

Offline sasquach

  • Posts: 560
Table Jack
« on: Nov 16, 2012, 22:49:58 »
Not a big project but it killed an afternoon . I needed a jack for my lift table and searching around the cheapest was about 100 bux . Found a set of plans an decided to give it a shot .

10 dollar junkyard jack

Had some steel laying around

Bent up a pan for the jack to go in

Welded the jack into the pan

Welded a top on

All done except for paint .

Online teddpage

  • Site Supporter
  • *
  • Posts: 1131
Re: Table Jack
« Reply #1 on: Nov 17, 2012, 17:57:51 »
Looks really good!  Nice solid base both top and bottom!  You might want to invest in some scrap wood incase you get a bike where the pipes interfere with the lower framerails.
1971 Honda CB450 Build -->>

"its a motor dude degrease the fucker and crack on" - axeugene27

Offline sasquach

  • Posts: 560
Re: Table Jack
« Reply #2 on: Nov 17, 2012, 19:23:21 »
Already have that covered .

Offline BIG E

  • Posts: 59
Re: Table Jack
« Reply #3 on: Nov 18, 2012, 22:00:04 »
Nice and simple. How about a link to the plans.

Offline Nebr_Rex

  • Site Supporter
  • *
  • Posts: 671
Re: Table Jack
« Reply #4 on: Nov 18, 2012, 22:30:16 »
I like it.
I use a similar jack, without the modifications.
K & L sells one like yours for ridiculous money.
Good to see someone taking charge of the situation and constructing something useful.