Quantcast
collapse

www.dimecitycycles.com

www.cognitomoto.com

https://www.townmoto.com/collections/vanson-leathers

www.speedmotoco.com

www.CITYLIMITMOTO.com

www.jadusmotorcycleparts.com

www.lostapostlejewelry.com

www.sparckmoto.com

www.pistonsociety.com


Author Topic: Long awaited CB200 Build  (Read 22470 times)

Offline Alex jb

  • Posts: 339
Re: Long awaited CB200 Build
« Reply #110 on: Apr 10, 2018, 14:06:31 »
Nice job, is it the same output as original?
Mind if I ask what it cost ya?


Sent from my iPhone using Tapatalk

Offline bex

  • Posts: 109
Re: Long awaited CB200 Build
« Reply #111 on: Apr 10, 2018, 14:38:47 »
I havenít tested it but I think so, it was actually working before but the coatings were starting to fail so Iím not sure it would have lasted too long.

Cheap, £130 quid!

Offline MickyC

  • DTT BOTM WINNER
  • *
  • Posts: 1108
Re: Long awaited CB200 Build
« Reply #112 on: Apr 13, 2018, 18:42:06 »
What a awesome build. May I ask what caliper that front brembo is from. Looking to upgrade my cb200 front but am struggling to find a small one to fit.


Sent from my iPhone using DO THE TON

Offline bex

  • Posts: 109
Re: Long awaited CB200 Build
« Reply #113 on: Apr 13, 2018, 18:49:44 »
It's actually a rear caliper, as you say, nothing decent for the front fits these little bikes. I'm not even sure this setup is going to work but we'll see.

From memory its one of these: https://www.biketorqueracing.co.uk/buy/brembo-brembo-oe-rear-brake-caliper-black/20516181.htm

Offline bex

  • Posts: 109
Re: Long awaited CB200 Build
« Reply #114 on: Apr 16, 2018, 14:38:39 »
Some crankcase rebuilding pics.










Offline teazer

  • DTT SUPPORTER
  • *
  • DTT BOTM WINNER
  • *
  • Posts: 9200
Re: Long awaited CB200 Build
« Reply #115 on: Apr 16, 2018, 22:31:06 »
What size are the carbs bored to now?

Offline canyoncarver

  • DTT SUPPORTER
  • *
  • Posts: 4012
  • 'hacking is learning'
Re: Long awaited CB200 Build
« Reply #116 on: Apr 17, 2018, 23:02:50 »
What a cool build!

Offline Alex jb

  • Posts: 339
Re: Long awaited CB200 Build
« Reply #117 on: Apr 18, 2018, 14:22:04 »
Thatís painfully clean!

Keep at it, itíll run in no time


Sent from my iPhone using Tapatalk

Offline bex

  • Posts: 109
Long awaited CB200 Build
« Reply #118 on: Apr 20, 2018, 12:00:25 »
Capellini adjustable crankcase breather



Offline Alex jb

  • Posts: 339
Re: Long awaited CB200 Build
« Reply #119 on: Apr 20, 2018, 13:35:25 »
Thatís very nice looking.

Do you need that size for venting a crank case?
I donít know, just asking