ZenMoto
New Member
Okay, not a ton of progress to report ...but I've been busy.
Finally got all my "black" parts off to the powdercoater and finished polishing the last of the aluminum bits so they're ready for Cerakote when I pick up the first batch. The beauty of doing the black bits first is that I can then Cerakote the fork legs (over the black powder coat) and they will be virtually chip-proof.
I should have snapped some before / after, but I ground off the extra mounting point on the left fork leg and filed down the casting seam on both legs then sanded them flush & smooth ...when they get back from powder they should look factory clean.
As for the aluminum, since we all like photos, here is the batch, ready for coating. ...man, that little points cover was a real mother!!! lol
Finally got all my "black" parts off to the powdercoater and finished polishing the last of the aluminum bits so they're ready for Cerakote when I pick up the first batch. The beauty of doing the black bits first is that I can then Cerakote the fork legs (over the black powder coat) and they will be virtually chip-proof.
I should have snapped some before / after, but I ground off the extra mounting point on the left fork leg and filed down the casting seam on both legs then sanded them flush & smooth ...when they get back from powder they should look factory clean.
As for the aluminum, since we all like photos, here is the batch, ready for coating. ...man, that little points cover was a real mother!!! lol