collapse

www.dimecitycycles.com


www.restocycle.com

www.CITYLIMITMOTO.com

www.jadusmotorcycleparts.com

www.bisonmotorsports.com

www.speedmotoco.com

www.lostapostlejewelry.com

www.cognitomoto.com

www.townmoto.com

www.sparckmoto.com

www.Moto-Madness.com

www.pistonsociety.com

www.steeltowngarage.com

GET DTT UPDATES ON FACEBOOK AND TWITTER

Author Topic: Walnut service bench, all done but the finishing.  (Read 2522 times)


Offline trek97

  • DTT SUPPORTER
  • *
  • DTT BOTM WINNER
  • *
  • Posts: 5632
Re: Walnut service bench
« Reply #91 on: Today at 00:59:48 »
So, will my chopper fit on it?

Possibly, 50" from front axel to rear of engine or center stand is max I would put on it.
Loading it alone...It may hold something a bit longer but I wouldn't chance it. 
As long as the engine is "mostly" forward of the pivot, it could work.
With a buddy to help hold the front from tipping back, until situated and locked down.  Yes definitley longer. 
« Last Edit: Today at 01:01:28 by trek97 »

Offline trek97

  • DTT SUPPORTER
  • *
  • DTT BOTM WINNER
  • *
  • Posts: 5632
Re: Walnut service bench, all done but the finishing.
« Reply #92 on: Today at 15:34:32 »
All done but the finishing...castors, tire chock...should be here Wednesday.  Thanks Irc for your great ideas.   8)
Along w a small safety prop under the ramp end.

After some reading,  Ill do another few coats of oil. 

In a couple weeks Tung oil will cure hard.  I can then buff it and apply Shellac or just leave it as is.

















« Last Edit: Today at 15:49:02 by trek97 »


Offline cbrianroll

  • Posts: 207
Re: Walnut service bench
« Reply #94 on: Today at 15:42:22 »
That's rad, great job!

Offline trek97

  • DTT SUPPORTER
  • *
  • DTT BOTM WINNER
  • *
  • Posts: 5632
Re: Walnut service bench, all done but the finishing.
« Reply #95 on: Today at 15:46:37 »
Thanks guys.

Offline doc_rot

  • DTT BOTM WINNER
  • *
  • DTT SUPPORTER
  • *
  • Posts: 1049
  • Oh the usual... I bowl, I drive around...
Re: Walnut service bench, all done but the finishing.
« Reply #96 on: Today at 17:16:31 »
Very nice!

Offline trek97

  • DTT SUPPORTER
  • *
  • DTT BOTM WINNER
  • *
  • Posts: 5632
Re: Walnut service bench, all done but the finishing.
« Reply #97 on: Today at 19:31:29 »
Very nice!

Thanks bud, the construction is rock solid. 
The router-ing is definitley amateur hour.   ;D 
Rach bought me that router like 15 years ago, and this was its first time out of the box.   ::)

But its the imperfections that makes up its charms....right?