collapse

www.dimecitycycles.com

www.cognitomoto.com

https://www.townmoto.com/collections/vanson-leathers

www.speedmotoco.com

www.CITYLIMITMOTO.com

www.jadusmotorcycleparts.com

www.lostapostlejewelry.com

www.sparckmoto.com

www.pistonsociety.com


Author Topic: Making a rear seat cowl  (Read 465 times)

Offline gt alex

  • Posts: 43
Making a rear seat cowl
« on: Feb 11, 2019, 17:13:49 »
At this point about 4 hrs of work on the plug I will use to make a fiberglass mould.
So far i have used 
               Some old timber slats (pre warped with slighht curve)
               thick card board
               peace of 3mm ply i snapped in peaces (for front curve
               about 6 hot glue sticks
               and some 5min epoxy glue to add rigidity

Offline gt alex

  • Posts: 43
Re: Making a rear seat cowl
« Reply #1 on: Feb 25, 2019, 08:11:27 »
The plug is nearly finished should be making the mould this weekend