Recent content by apreludem

I know I'm supposed to synchronize them but it says to do it with a warm engine...about ten minutes of driving...that's impossible at this time. The manual says there are two screws used for calibrating the idle. One has a black little wheel that you can grip and spin and the others are...

Ok that worked. But now I can't seem to get he idle right....I'll hold the choke in the close position...fires right up but a few seconds later the idle is irratic and it will shoot to 3-3.5k...so I'll open the choke a little and it will drop but sometimes will stall.

Do they twist off? Seems impossible to move...

Ok so this is where I am now. I started the bike yesterday and noticed only one side would fire right away but the right side would not. Now my coil pack and wires look like crap cause when we put starter fluid in the spark plug hole it fired then died. Also I noticed fuel at the tip of the hose...

Yes, the wires are corroded a their protective covering basically falls off on its own. Also I tried to see if there was any spark when I would try to start the engine and nothing. Any ideas?

For a 78 cb400t did these come as a whole unit? Or is there a way to remove the cables from the coil pack?

thank you so much .

ill check the headlight since that's the only thing i have on at the moment lol

as title says, i took my real wheel apart because of the "play" i was getting and i see that the damper rubber is worn out and cracked in several places. I need to replace these but i have no idea where to buy them from..i tried ebay and only one match came up..but it looked just as bad as mine.

today i finally finished with what i was doing to it and managed to get power to it....once the ignition was turned to "on" my lights came on, even the ones in the gauge cluster...then i hear some noise coming from where the electrical stuff is at...and then all power is shut down. i check the...

Sorry I posted this somewhere else already but I figured this is the best place...I found the site that sells them, what dimensions did you end up putting on your bike? Thanks man

We're your UNi Air filters from eBay? This is exactly what I'm doing...I even have the same bars...been trying to salvage the tank for a long ass time now.

awesome! thanks again man!

i have the carbs out...will that work?

ty thunderchild :)