Recent content by Bcon615

  1. Bcon615

    81 CB650C build and introduction

    So I was looking back at this old post, and was shocked when I saw "Aimless Moto". You're the guy with the KZ400 on YouTube!!!!! I'm currently working on a '76 KZ400 and you're bike is 100% my inspiration (I even bought that same seat cover haha). But yeah, this CB650C project is on hold until...
  2. Bcon615

    Replacement ignition switch for '76 KZ400

    So, I'm looking around for a replacement ignition switch for my 1976 KZ400. For some reason, it seems that it is tough to find anything not heavily used for a '76. Does anyone know of a place that makes replacements? I also see a lot of affordable replacements on eBay, but they seem to be for...
  3. Bcon615

    So you bought a CM400 / CB400T, now what...(50+ Build Links!)

    Nice! Where did you get that headlight from?!
  4. Bcon615

    81 CB650C build and introduction

    Time for an update... Put the shocks on and just laid the seat on the frame since I haven't started modifying that yet :o Once I was able to get the cylinder jug off (which took hours) I think I have found what was causing the engine to be seized up. The next two pictures are from the...
  5. Bcon615

    Post a pic of your motorcycle as it sits

    I feel like both bikes are missing something... Sent from my iPhone using Tapatalk
  6. Bcon615

    81 CB650C build and introduction

    Welp the engine is out... At least now this will give me an opportunity to paint the frame. Also was able to get the grips and handlebar installed. I ordered a gasket set and piston rings so until they get here I am just taking apart the engine, then cleaning and painting all the covers...
  7. Bcon615

    81 CB650C build and introduction

    Finally had some time to work on the CB650C, been busy trying to buy my first house and put together a YZ450F engine. So I pulled the plugs and tried rocking the bike back and forth, and no luck. Is there a way to manually crank the motor? Also, it seems the transmission is only willing to go...
  8. Bcon615

    81 CB650C build and introduction

    I didn't even think about cranking amps. I'm reading 12V on the terminals with an ohmmeter. I even tried using the battery from my R6 and still no luck. But I will look into the cranking amps of the battery and requirements. Thank you
  9. Bcon615

    81 CB650C build and introduction

    Thanks man! The starter actually does whirr and spin but it is only for a split second. Even if I continue to press and hold the start button. I'm not sure if that is typical or a sign of a bad starter?
  10. Bcon615

    81 CB650C build and introduction

    Hello everyone, been a member here for a little over a year just reading and learning. However, with the weather warming up I finally took the plunge and bought my first project. A 1981 Honda CB650C for $700. Also, I want to start this build thread because I'm hoping it will motivate me to take...
Back
Top Bottom