Recent content by benngalaska

Hi I Know which rings go on the bottom ring but I cannot figure out which one is the top ring. one ring is just a black ring with no special bevels, chamfers, ect.. the other ring has a chamfer on the outside of the ring on the top and bottom. thanks!

thanks

would I need to get a new main jet as the mikuni isnt stock specs

When I engage the clutch on my bench the plates dont slide in and disconnect the motor from the main drive sprocket.

Hello, I am currently restoring a 1978 CB125S and while running tests on my bench with the engine I have found that the clutch will not engage. I was wondering if anyone would have some suggestions (I preferably do not want to take the clutch apart as I don't want to deal with the different...

lol most defiantly.

So how would I go about fixing the air box?

Barnett Thank you very much! I just looked up spigot carb (VM24) and I found exactly what I needed. My Bike is a cb125s. Thanks!

Re: Barnett it is done

4

3

2

1

Hello all. I need a new keihin carb for my honda cb125s. After hours of searching i have only found carbs that have a mounting scheme like this (see pic 1) but my carb looks like this (see pic 2) and the top of my engine looks like this (see 3&4) I cannot se ow a mounting flange works on this...

The stock carb had a hole in it. The stock carb also had a thick layer of white corundum all over it. Corundum is a major pain to scrub off. Also after further research I have heard nothing but good reviews for the mikuni vm22 26mm carb. What is the difference between the vm22 and the vm24?