Recent content by bigring

I need a '76 clutch lifter plate for my CB750. Please send me a PM or contact me at: craig underscore barlow at sympatico dot CA Cheers

Thanks in advance for reading. Looking for tire suggestions to fit onto my stock '76 cb750 rims. Wanting to go for the tracker look, want something safe, bike will be mostly on the street - odd time gravel roads. Was looking at these: Kenda K761 . . . . anyone try these? Anyone run the...

Bueller? Bueller? Bueller? Anyone? Anyone? . . . .

Hi, thanks in advance for reading.....just about to button up my crank cases ('76 Honda CB750) - my first bike, my first build, my first engine tear down and rebuild. I REALLY do not want to have to open it all back up after all the hard work I've put into it. I did a "dry run" and put the...

I'll be sure to that Manny - thanks for the advice! Anyone else ? Cheers

Awesome advice Scoot! Thanks! Keep it coming guys. Cheers

Hey, thanks for reading. I'm just about to put my '76 CB750 engine back together (after a much longer than I thought teardown and cleanup :o) with new gaskets, seals and hardware. Do you have any last bits of information for me? IE. "make sure to spray the head gasket with copper seal"...

Mine is sheered off. Need part 30231-300-010 #8http://www.cmsnl.com/honda-cb750k6-four-canada_model14381/partslist/E07.html#results in diagram Please PM me if you have one. Cheers

Looking for the lengths of the mounting bolts for my '76 CB 750. The PO had all sorts of mismatched bolts, nuts and washers. Some were much longer than they should be. All help would be appreciated - can't seem to find the lengths anywhere. Cheers.

Thanks Von - that's exactly what I'm going to do. I have a buddy who can do the welding for me. Hopefully all goes well. Cheers!

Okay, located the part - should be here March 3. But now how do I get that broken bolt out? There's not a lot to grab on. Mentioned on another form and someone mentioned to weld on a bolt and turn it out. Don' t have access to welding tools….could make it happen if I had to. Anyone got any...

'76 CB 750 in need of an advancer shaft #8 in the schematic PRODUCT NUMBER: 30231300010 Send me a PM or email me at: craig(underscore)barlow(at)sympatico(dot)ca cheers

Bike: '76 CB750 - two issues (presently :o) 1.) Taking out the crankshaft the other day I noticed the advancer shaft was slightly bent (before taking it all out)….hit the side of the case on the way out and SNAP. >:( F*ck! Check out the duct tape that the PO had put on it. Must have...

Digging your build Dude. Book marked.

Dude, really like where you are headed with your build. Getting lots of good ideas from this. Book marked! Cheers.