Recent content by BIKE MIKE

Took Monica on her maiden voyage, she rode great! Carbs definitely need synced up she was sputtering on deceleration and idle was a bit high but I'm so excited and relieved to have her on the road! Thank you everyone that's helped me out, I wouldn't have her on the road without all the info and...

I'm really looking forward to getting on the road! Sent from my SM-G930V using DO THE TON mobile app

All done with my clear coat on the tank and tail section. Final assembly will take place this week and carb sync asap to get her reliably road worthy! Sent from my SM-G930V using DO THE TON mobile app

Man that rear end is low... no bumps lol. She looks great though keep it up! Sent from my SM-G930V using DO THE TON mobile app

Replaced the plugs, reverified my connections and traced out every wire, checked my connections on the coils, plugs etc. then pushed the start button and... she fired up. I'm so excited right now! I'll hopefully get her on the road in a week or two, just in time for the cold weather to roll in...

Replaced the plugs and got her running! I appreciate the help, I'll update my build thread soon and hopefully be out on the road! Sent from my SM-G930V using DO THE TON mobile app

I'll check it over again and see if I can get it sorted out. I appreciate the help! Sent from my SM-G930V using DO THE TON mobile app

Black looks like it should go to the black for ignition and the black on reg/rec. I have the black for ignition going to lock input and reg/rec black going to aux output. If i hook the kill/start to aux out I get nothing to work. Sent from my SM-G930V using DO THE TON mobile app

. Sent from my SM-G930V using DO THE TON mobile app

I should clarify i am using the stock Honda right hand switch (start & kill) so all the wire colors on the schematic are the same as what are shown, the left hand switch is aftermarket (turn, hi/lo, & horn) all of those function properly. Here is the schematic, the black/white coming from the...

There are 3 wires coming off the handlebars I'm trying to figure out where they go. A black/red I have hooked up to the aux output of the munit. A blue/white going to the headlight lowbeam (I think this one is right). And a black that comes from the kill/start switch (my biggest headache) not...

My current set up is 81 cb750c with stock kill/start switch, motogadget m-unit, & a 4 wire ignition. I'm having trouble getting a spark and I know I'm doing something wrong. There are 3 wires coming off the handlebars I'm trying to figure out where they go. A black/red I have hooked up to the...

I did get cbr coils and I'm running a motogadget m-unit. I know about the relay mod, is it necessary with the munit? I'm getting everything to turn over and seems to be working correctly just no spark. I'm thinking I wired the ignition switch wrong. Sent from my SM-G930V using DO THE TON...

So currently the plugs and crankcase gasket are on order. I'm looking for some electrical help. Where should I be looking to solve the spark issue. I will replace the plugs but the fact that they don't have much run time on them and are just bit dirty lead me to believe they are not the issue. I...

Lots of frustration today, finished hooking up all the electrical after a few issues. Hooked up fuel and she started dumping gas on the floor. I realized I left one of the carb drains open when I cleaned them. Once that was sorted out I tried to start her with no luck. Verified all my...