Recent content by cb(x)

Yeah, Sweet. So much better than the Clymer. Feels like 1974 in there. Thanks a bunch. My son got interested in this stuff, but i am having all the fun!

Update... Was in the garage, and online reading, until around 1am. Float heights were way off. I tweaked them to the 21mm PJ suggested. then I noticed the right side didn't have any bounce so I cleaned the float valve needle (again) and put it back together. Then I checked the flow out of...

Thanks guys. So today I rechecked the points and the timing. I found the timing was way off. When I look into the cylinder with the plug out, i can see the valves move, so stuck valve is out. I have to check the float height again (doing that tonight) and I will have to buy a Carb Sync...

Any ideas?

Hey Guys, been lurking for a while and soaking up as much as I can from all the helpful wrenches in here. Hopefully someone can aim me in the right direction with this problem. Last summer my son comes home from school looking to build a cafe racer. He found a CB360 runner that needed some...

Not all Harley guys are willing to part with the $$ that easy, but I admit the dealers will take you for every penny. I like a good bargain and have done most of the stuff on my Softail by myself or at a fraction of the dealer cost. Having just gotten into the Cafe scene with my son (...

Hey! My son and I are working our way through a cb360. So far we are progressing well, but I hit a snag changing the turn signals. I noticed you installed the same ones (or so it appears). Dual Filament in the front, single in the rear. They light up fine and on cue, but don't flash. Does...