Recent content by CharlieBmore

I have been working on this thing for a bit. Just purchased a VM36 mikuni carb from Sudco. The problem is with the custom frame I have it hits the downtube under the seat when the air filter or velocity stack are on. Anyone know of a 45 degree manifold for these? Sent from my iPhone using...

The foot controls and pegs are from Factory Metal Works out of Charlotte NC, they helped me with the early model rear drum brake as well. Great guys down there. Sent from my iPhone using DO THE TON

Thanks guys, Well she should be done by the end of September if everything goes well. The bars were custom built by Craig Tirey at Front Street Cycle in Ohio. I bought a set of bars from him years ago that I loved the look of, so asked if he could remake them with some slight changes and in...

Been working on this bike for a while now, between moving cross country, remodeling a house, and life, it's close to being done. Just some small stuff to complete it. If anyone knows a good place to grab a Triumph clutch cable with Harley type lever end, let me know. You can see more updates...

Do you have a recommendation on a brand? Sent from my iPhone using DO THE TON

Painted very well in British green. Metal covers, NOT the fiberglass Excellent condition, make an offer. Sent from my iPhone using DO THE TON

Amal came back with: At 6,800 ft the 190 Main jet size would fall to around 150 and the 106 needle jets would go down to the 105 size. Anyone know how far off they are?

Hey anyone in Colorado tune a vintage bonneville with the original amal carbs? Was wondering what jets and pilots to use at 6,800 ft ?

I was thinking of using AN fittings to run nice hard lines on my '74 triumph bobber. Has anyone done this or have suggestions on what type to use with steel vs. aluminum?

So I'm building a Hyper motard out of a 1969 TRW25 that i just finished the motor rebuild on. What I'm trying to figure out is what swingarms I could replace the stock swing arm with. I'd prefer a dirt bike swingarm to give me the height I need and give it a more modern look. So the stock...

Got the kit and installed it. Love it. The magera levels are very nice, will start using them on other projects http://tonupboulder.com/hydraulic-clutch-conversion/ Sent from my iPhone using DO THE TON

drum or disk? give me a list of items you are looking for and ill go through my stash.

Anyone have one in a vintage Triumph? I've been looking at the ones that are internal like this: http://www.britcycle.com/Products/55820.htm But found this one: http://www.btosports.com/p/MGHC Was wondering if anyone had any opinions? My forearms are getting too big riding around town... :P

Then i better hurry up... ;) Just finished setting my shop up and got the electrical done today, and rolled the cafe in. Need to pull the head off to replace the gasket and figured I'd do some metal work while i'm at it. tweak it at least once a year. I'm up in Boulder and just starting to...

Always looking for vintage triumph stuff... disk rear hubs, tanks, frames, basket case motors, etc. I have lots of extra used triumph parts as well, let me know what you are looking for and what you have, maybe we can make a deal.