Recent content by Dave Walters

Price? Odometer mileage?

I am looking to replace my stock cb160 speedo. It is old and crusty and I am not looking to drop $100 bucks on a used stock one to replace it. I wouldn't mind making up a oval shaped plate and drilling a hole in it to mount a nice mini round speedo and then do the indicator lights on the...

Tried honing my jugs but in order to clean them up fully I will be out of spec for the std size pistons. I have a set of STD size pistons with fresh new rings. $80 for the pair? or best offer. Text me: 260-417-4789 Located: Fort Wayne, IN Will have a pic to add later.

2 x Rebuilt Keihin 3-D Carbs (All new gaskets, jets, perfect diaphragms, etc) Bags of new parts, gaskets Sirius consolidated jet kit and case! + additional jets purchased from ebay. 70/71 110/115/120/125/130 jets TONS OF JETS! Spare diaphragm, float, remnants of at least 4 rebuild kits, tons...

1975 CB125 single for sale: This is what I have done to it: Fabricated electrical compartment onto air box (no side covers needed) New Tires (Michelin gazelle) Rebuilt Carb custom exhaust painted with high heat black paint. Cb100 front wheel Chopped Rear fender Start of a seat pan Painted rear...

I will take one!

front caliper off one of the cb360's? I am from fort wayne.

I am more than likely not using that caliper I got. Just requires a disc that is too thin. I am confident in my design to retrofit a new plate and piston setup to my original pivot arm but like you said liability would be bad so I will more than likely not sell them.

In the process of measuring my stock brake to get my bracket position dimensions I had a great idea. I am designing a custom piece with a hydraulic piston that adapts to the stock pivot arm and uses stock pads. In theory and design so far it should work. Its just a matter of finding a good...

Few hiccups already. This is a caliper made for the left side. I could still mount it traditionall in front of the fork and just make the bracket to work Or I coul mount it behin the fork and keep it nice and tight. Caliper only allows for a disc with .200" thickness so 20/100 of an inch...

Hey man. You should swing by sometime and see my garage. text me 260-417-4789

Sorry nope dont have it

I hail from Fort Wayne and am close to having my cb125 running.

Wow I am stoked to see a lifan drop in. My buddy has a 1964 c110 honda with a 140 horizontal lifan and it runs great. I am interested in this 200cc drop in. Was it tough to do?

If the brass pieces are mushroomed they might be able to be fixed or needed replaced.