Recent content by futureprimitivemoto

I really appreciate the response. The long term goal with the bike was always to go to a CBR front end. These forks work but the valving in them is completely wrong for the street, they're heavy, and aesthetically they're not very nice.

Thanks, ill take it from here

Putting the radiator in the tail was considered but I decided to mount it under the lower frame rails. An aluminum belly pan is in the works, tricky aerodynamics will be the key here. Creating high pressure on top of the radiator via air ducts and fans while using the belly pan to create low...

Yes but they cost a fortune and are only momentary contact therefore requiring use of their also expensive digital fusebox. I also didnt like the switch on the backside.

Few more closups These are handlebar switches I designed and had CNC'd. 2a switches, can be latching or momentary contact, NO or NC, switch housing have allocations for routing through the bars or externally. Because im using clip ons I decided to just route external. Better shot of the...

Fixed!!

Hey all, This build is quite a ways along already, but I thought I would share with everyone here on DTT I bought a CB360 for $300 that had been parked since the mid 90's. The pistons were so seized in the bore they needed an air hammer for removal, so the engine went in the scrap bin and I...