Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
Let the battery trickle for a day and tried one last time. 8)
Only getting 12VAC at the whites with a little revving but the battery is clearly charging, drops down almost a volt at idle when removing the black signal wire. Thanks for your patience, the stator may be going but we know the R/R...
Charged the battery up to 13 volts, key on shows .125VDC between green through the coil and chassis ground.
The green/brown field coil field wire to ground is showing 1.2-1.4MOhms
Put a 20 amp fuse in, 12.5 battery voltage and 12.2VDC through signal wire and white wire hooked to brown field coil.
Loose Green wire R/R connected to green field coil now shows .06VDC.
So we have battery voltage on the white wire through the R/R following your wiring diagram.
Pulling the power from black signal removes 12V from white.
Going to brown on the field coil with the white wire and green/green creates a spark that blows my signal 12VDC fuse.
Between green and brown...
I have probably tested them all through troubleshooting, but for the sake of getting the electromag/field coil functioning I'm eliminating the harness by going direct from battery/ground into the R/R and through the stator/coil without any success.
I'm one step away from replacing the stator...
That loose green has direct continuity to chassis ground, that can’t be right from your diagram.
In fact I just checked every terminal on the entire R/R and they all have some sort of continuity through each other.
No sir, if black is disconnected no voltage in either white/green loose with plug red +12V/green ground and verified <.1 resistance. Battery is 12.5~13.0 static.
Do you want the plug green chassis grounded or to negative battery?
Also, verified there was voltage through loose green and white wires to the stator last night. Going to voltage with the black wire makes every wire powered except the white ones I want and green plug negative.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.