Recent content by jakeZ70

https://vermont.craigslist.org/mcy/d/honda-cb200-twin-1976-cafe/6601278285.html

I like the battery placement. https://nh.craigslist.org/mcy/d/cb-350/6531061721.html

I'm looking for a Top Fork Bridge for a 1973 Honda CB 350G. If you have one ping we with details, and cost. Thanks.

I picked up a 73 350G last year. The previous owner had something go bad with the starter switch, and they remedied it with a trip to the local RadioShack. I picked up a used set of controls from ebay, but they appear to be a couple of wires short. Coming out of the bucket I have a couple of...

Will POR-15 fill pinholes, or is Red-Kote a better option?

This didn't happen until I applied the new paint and clear coat. I had previously used lacquer, and that was unaffected. This is on the top of the tank, and the color doesn't seem to be affected, only the clear.

I recently re-painted my tank using spray bombs mixed at Napa, and I finished with Spray Max 2k clear coat. It looked fine for about a week, but then a couple of bubble spots appeared. One is near the front weld points of the tank, so it isn't very noticeable, and I don't care. The other is of...

I'm looking for a points cover with screws, and a float bowl for a 73 CB 350. I believe the points cover is the same for the all years of the CB350 and covers for the CL350, SL350, and the CB250 will also fit...

Cool. Thanks.

Wow. Thanks. I believe it's a second generation. The older carbs I have are more square.

That's what I was thinking. Just wasn't sure if it would hold up to the fuel, and heat. Thanks!

The hole is actually in the bowl, not the float.

I recently picked up a 1973 Honda CB350G. I've pulled the carbs, and after cleaning them, I've discovered a few small holes in one of the float bowls. Can this be fixed? If it can be, what is the best method? Solder, JB Weld, or just purchase a new one? I of course have four CB350 carbs sitting...

Please do. Thanks!

Looking good. What type of levers are those? Stupid question, but does the geometry make them any easier to pull? I dislocated my thumb a number of years ago, and clutching for an hour or two causes pain to the point when I can barely pull the lever. Getting old has its drawbacks.