Recent content by Jocassee

I have been keeping an eye on the choke, it is not moving. I will check on the valves as well. Thanks for the ideas so far.

I assume you are talking about the cyclinder valves? No I have not, would that require taking the engine apart?

So I have this beautiful CB360 that I picked up cheap. It ran OK when I got it but since then seems to have degenerated for some reason. I have tested all the electictrical which seems to be working fine, I have spark, compression, I just replaced and gapped the points. The left cyclinder has...

You got a PM :)

Has anyone tried SC yet? I have a pretty CB360 that needs to get on the road.

I did finally get this thing apart. There was some movement in it already so I put an air compressor on it and it popped right out. There is only a very small amount of pitting on it with a little rust. I think my main problem stemmed from the monumental amount of sludge in the bottom of that thing.

I'm a relative bike n00b. I've had the calipers off my CB and apparently that chrome piston in there is supposed to come all the way out. Any suggestions on how to make that happen?