Recent content by Jutboy

Could you cut out the top bar of the triangle smooth out then re weld following the angle of the tube top left make the bar a lot shorter Sent from my iPhone using DO THE TON

Nice looking bike Not a direct answer but if you put the picture into google image search you might find more info about that bike Sent from my iPhone using DO THE TON

ID this Caliper Would it be this one mount looks the same

Re: 2x stroke street tracker - probable project? This is on eBay at the minute 162439376031 If forks are straight could get a amount of money back selling the frame Weight wise if you are not seething up for passenger I wouldn't see any issues Sent from my iPhone using DO THE TON

Re: 2x stroke street tracker - probable project? The QINGQI qm125, SINNIS apache(same bike) would most probably have the parts you want(quite nice wheels) I believe they are based off gn125. Some go through eBay spares repair Sent from my iPhone using DO THE TON

I am following I have liked these since I saw so-low Sheena bike

this is a bike i had in 2007 i replaced rear shock with a bar then mounted a sprung seat all so removed the oil tank side panel coverers for some thing slimmer

Here are some pics for you This is the best parts image it is a shaft with hole drilled in end with washer then split pin

Did you get the pics you needed if not will do tonight ;)

this is a odd looking beastie http://www.ebay.co.uk/itm/262792322202?_trksid=p2060353.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT Must be a cafe as it's painted on tank

If this is like the older model (1 indicator idiot light) you have to add resistors to fit led indicators. Have a look at cafe seat with hump would look cool Sent from my iPhone using DO THE TON

In Japan these are called st250 and have a very big cult following in America you can get on bolt in kits from bluecollarboobers ( I am uk ) might give you some ideas. I own the older model which is no injection . Sent from my iPhone using DO THE TON

Sorry what I thought was measure head of banjo bolt m8,m10 to figure hole size in banjo fitting. Then no need to strip, that's why I wondered about banjo bolt On a plus size just found a shorter speedo cable (comes gt250/z50) Sent from my iPhone using DO THE TON

I am in Norfolk near Norwich I thought it would be the 10 mm still in use some days (rolling project) and wanted to save stripping before I ordered if I could. I have looked at some cables from China just checking measurements before ordering this weekend. Hope to get before Christmas[emoji3]...