Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
I only ran these for a couple hundred miles. They worked well but I went to velocity stacks just for the look. Like new genuine KandN, not cheap eBay knock offs. 40mm clamp diameter. Should fit many models, check your carb intake diameters. Yes I can recommend proper jets, it’s not as hard as...
Fits CB750F Super Sport - 1975-1976
CB750K - 1969-1976 I have custom drilled and mounted a latching stainless button. I use it for the kill switch, but could also be used for the high low beam. $75 shipped.
Here are photos I did of 2 and 4 after getting the engine good and hot and then a good couple of minutes at highway speed with the last 20 seconds at WOT. These are not new plugs but had been used with a previously rich condition so I think they are black and sooty from that. With the changes...
Yeah these are slide carbs so in is richer. I just wonder if the popping while deceleration with the throttle closed is a lean condition or rich?
Yeah Son!
Update. Turns out, float height was way off so I didn't have enough fuel in the bowls. Reset float height and confirmed with clear tube method that my fuel level was 2-4mm below the bowl/mating surface. This previously lean condition I had compensated for by raising the needles to the last clip...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.