Recent content by ninehudson

anybody have some old, STRAIGHT, valves they want to sell? or an old top end? looking for valves. Thanks! 1969 cb450 engine PM me or email

how much for the motor and shipping to 92705?? PM me

where to buy new ones?? i know its prob expensive to buy new but does mikuni make new carbs for the 450? any help and shortcuts .... and what size to use?

did you sell this frame already? i know its been up for a while but looking hard for a 450 frame. any idea on shipping costs to california?

tons of stuff on this bike, so many to list. new top end rebuild and total carb rebuild and jet. so much going on with this bike, way fast. shoot an offer and ill answer any questions... located in southern california email is Bmoscos@gmail.com

yeah, the compression is dead on, i was thinking valves but i just wasnt sure. haven't had much time in the last week to try and get my hands dirty. im also getting some backfire, not sure if that would be related to buring oil or not

totally rebuilt my BS34 mikuni carbs, re-jetted them for my 4 into 1 exhaust, the bike is running faster and idles like a champ. now, i was burning a small amount of oil before i started working on the bike. now, after i ran through the carbs and rebuilt them, it seems like im buring even a...

yeah, no way im spending that much on wiring. if anything i was thinking about r-wiring the whole system from a chopper/bobber style. super simple. but that would take a ton of time. ill figure out the headlight and switch. thanks for the info

So I recently got a rebuilt kz1000 and the bike is great, but not good enough yet. I pulled off all the extra electrical crap and I'm only running headlight, tailights, stop/start high low switch. Who the heck knows of a better way to wire this! Or a pre made wiring harness??? Obviously I have...

trying to find out what size my fork tubes are so i can slap on a pair of clip on bars. anybody know what size in mm the forks are?? and.......where to find a descent pair of clip ons . something in the 100 dollar range?

im not made of money and im trying to find a descent pair that wont break and throw me off a bridge. i think i have seen a couple posts about 33mm clip ons and they are just stupid hard to find. help

well whats happening is the clutch is slipping at around 5-7000 rpms. i figured it was the plates because they do wear out and my bike was ridden a ton before i bought it. 1 - where can i find those race springs for a cb 350 four, not a twin. 2 - if its not the clutch i would love input

trying to get a clutch for my cb350 four and i was wondering if i should just get one that fits exactly to my bike or is there a better clutch from a different model that will fit....? maybe from a 400/500/750? or should i just keep my housing and buy new plates? they run a little expensive but...

yeah, im going to get them synced next week or week after, im very sure that its one of couple running problems i have. there is a great shop here in orange county that will def help me out

it was standing for a long time without running, it gets quiet when i give it gas, it pulls fine when i ride it, i just cant figure out what the hell it is. hasnt been serviced by anybody but my dad is a mechanic and i was thinking about bringing it down to him. he has worked on bikes before and...