Recent content by PJs Garage

It's real close when you go over bumps. I ended up trimming a small amount off to reduce the risk of contact of the tire.

This is a update on the Cafe bike that I built. Finished the Build in August of 2014. It's first ride was in Sturgis, South Dakota for the 2014 rally. Sturgis is a life changing place everyone should go. The bike has been a weekend riding bike. I recently had a child and it is time to sell the...

Sorry for the long wait. Due to some changes in my job I will not be going to Bonneville yet. Here are some updated pics of the build.

I like your build. Can't wait to see it finished.

Looks good. What do you plan on doing for your set? Im mid ship in building mine.

Does anyone make the OE replacement or a reproduction?

I hope the hot mess turns out. Im following

Re: Bonneville 78 CB750F I lightly balanced the bike by the bar. I considered purchasing a tail, but I wanted a specific design. I would like to have a mold made that will bring the cost down. I see a couple of Sanctioning body's for Bonneville. Not sure which one is better. It will be 130-140 mph

Re: Bonneville 78 CB750F I planned on adding a layer to the inside, but the mat we used was thick. I could use it as a boat if needed. Thanks for the info.

Re: Bonneville 78 CB750F After 16 hour of foam and fiberglass work the tail is at the painter being prepped for paint. See pictures above. Thank you all for the support.

Re: Bonneville 78 CB750F We started on the tail today. It needs some fine tuning. It will be awesome. Im excited!

Thanks for the info. Anybody else???

Thanks for the info.

I like the brass fuel cap. Did you end up using it?

Good luck with the new project. I hope to see it all finished.