Recent content by pop_vamp13

Need a little help. Long story short, I am located in Corbin, KY. I have a cb750 project I have been riding/working on/beating on with a hammer/crashing for the last few years. I have finally taken some time and money and replaced a lot of worn out parts. Basically all that I have left to...

Need a little help. Long story short, I am located in Corbin, KY. I have a cb750 project I have been riding/working on/beating on with a hammer/crashing for the last few years. I have finally taken some time and money and replaced a lot of worn out parts. Basically all that I have left to...

Can it be done? Traded an old cl100 to a cd175, almost exact same condition, just always wanted a cd. I have searched all over the net, and had a lot of trouble finding the model of the cd carb. I have found a few mm' measurement, but nothing else. Is it possible to swap one of the cb175...

It's sharpie. I got the idea for the designs on the tank from a day of the dead inspired tattoo I saw on a chick. I drew out my designs on the bare metal, and used starting fluid sprayed on a rag to wipe off my mistakes. When I got it how I wanted it, I sprayed a super light coat of clear over...

It surprised me too, but for some reason they did turn out looking alright! Thanks for the welcome. I can vouch 100% for the rough riding part of that haha. You can ride down 10 miles of good road, and get home feeling like it was 200 miles of bad road ;D The serial number on the engine is...

Tell you what...... I'm still in college... You make a trip to fix these valves.... I'll set up the college aged lady semi-amateur chopstick gynocology. ;D

Thanks, ill check out the coil trigger wires, and the points. A few of the valves have such a large gap, that even if you screwed the tappet all the way in, it would still have gap much larger that what the manual has them being adjusted to. Do you think that these particular valves are stuck...

Before & After

College student from Corbin, Ky. Doing my first bike build, learning as I go. Always worked on and built off road trucks and buggies, just recently added bike building as a hobby. Hope I can learn from the people here. Here are some before, during, and almost completed after pictures of the...

First bike build. Picked up a cb750 at a local salvage yard, a little rough, but ran. Changed the oil, plugs, etc. Cruised around a little, no more than probably 50-60 miles, started getting some oil coming out of the exhaust, with reduced power to the point where it wouldnt even pull up my...