Recent content by RobbyD

I've not liked any bike I've seen with that swing arm/rear wheel swap but...yours pulls it off perfect, i like it a lot!!

Seen this on another forum but with cars and thought it was cool Post up a pic of how you bike sits. Head out to the garage, basement shop, etc and snap a pic. Simple as that!! I'll start

Re: Fuel injected Cb450 build Looking forward to how this turns out. Keep up the good work man

Tank has some dings which you can see circled with paint marker. Comes with both badges, unknown condition petcock and gas cap with key. Only reason for selling is I got a great deal on a E tank asking 60$ shipped, I'm located in Independence, Ky 41051 i only ship to the lower 48 states

My old cb550, I think it fit the frame pretty good

You can do it in the frame. If it was me I'd go ahead and do valve seals and clean/lap the valves while you have it apart.

Love the color of that tank

Just bought a gs450e tank for 52$ shipped!! A little rough but fixable Bought it off a guy on Craigslist about 3 1/2 hours from me

Picked up this basket case 81 gs450. Took 4 hours of driving but worth it for 200$ w/ a title.

Thank you fellas for the replies.

Thanks for the response. As of right now I haven't bought a project bike yet. Now that my zx7r is pretty much finished its going up for sale. I love the bike but I enjoy wrenching just as much as riding. When the zx7r does sell, I'll be looking for a kz650 in project form. Everything...

Simple question, was it worth it? Do you feel the performance and comfort was improved or decreased or really not noticeable. I have an idea for my next build and it consists of a old school cafe look with modern suspension front and rear and modern wheels. Think... 67 mustang with todays...

These fairings were purchased a month and a half ago but finally just recieved. For those who remember, my 600$ zx7r.. Tank is still orange and needs painted but I have the paint to do it.

Thanks for the suggestions guys. I ended up plastic welding it. It doesn't look pretty but it's actually extremly strong. On one of the broken headlight taps I reinforced it on each side by using a piece of paper clip melted into it then covered back up with some filler. I just used a crappy...

Some of you may seen in the recent purchase thread I got a smokin deal on a 01 zx7r. There's a couple plastic pieces broke I need to fix. Two posts on the back of the gauge cluster and a mounting tab on the back of the headlight. Can someone recommend a strong epoxy or does anyone have any...