Recent content by Rocketeer85

Towel on the ground lolz

So I have a CB350F and the person I bought it from used it as a daily driver in great shape. But one weird thing I noticed is every pipe I ordered was too small the diameter of the end of the header is over 2 inches wide. Someone said it was a header for a cb750. The muffler was custom made and...

HAAAA wtf... I did it!! woop! Starter cable connected to the starter selonoid.

Cancel that. Going through handbook and starter connects to the battery...

*UPDATE* Ok so looking over the diagram I notice after tracing all the wires that there is no wire running from the Starter Selonoid to the starter. Unless its in a harness somewhere I cannot see, but every wire coming out of it is clearly visible. Also there are 2 terminals on top which one...

Oh ya and what I failed to mention. Ive installed new dyna S ignition, dyna coils, new plugs, and new graphite wires. Not sure if that helps.

Ok so somewhat good news. I completely rewired everything grounded everything (I think) I needed to ground to the bike and installed a different ignition kill switch which is getting 12v and hooked it to the red wire from the coils. This time instead of getting nothing I get a spark from the...

Sorry its a CB350F.

ALSO...This is one that I cannot find in the Diagram. Call me a noob. But I cant seem to figure out if it goes anywhere. And last but not least. Is there anywhere SPECIFIC I need to ground this on the bike>? Its coming off the main harness by the celanoid.

On dyna 5ohm coils does it matter if the points are on the top or bottom? Also I guess I should ask if the 12v ignition wire connecting to the 2 coils should be on top or bottom of the coils. Also so far Ive seen 2 things that need to be grounded. One coming from the rectifier I believe, one...

After many hours of trying to figure out why the hell my wires are different from the diagram...I realize the horn and engine start button look like twins ;D . So I installed new Dyna coils, dyna s ignition, graphite wires, and new plugs. Keep in mind the bike worked fine before. So wires are...

BINGO! And clearance is perfect.

CB350F. Apparently everything is different on this bike.. Hard to find anything.

Ya I think im going to attempt to modify the old one.. Thanks!