Recent content by steveinwa

I stripped mine down and just painted distressed stripes, you can use boshield on it, developed by Boeing to protect metal, been on it for 2 years and no rust but some on the inside, will have to fix that before I put gas in it.

Finally got it running good, now having clutch issues, fun little ride but it's cold here in the PNW.

Some new shots, got sick of working with the controls and wiring so I added a metal panel on the triple clamp, the on switch and start button are fun but having clutch issues, think it's shot so finally got it tuned to run good without backfire but hopefully just needs sanding.

Thanks and they are just stickers and come off, they are not perm, just my inspiration to do old time like 60's when cars were still real and hand made of steel and Aluminum instead of fiberglass.

Ok, bought some 2/4" steel box time to get back on this bike, between the sailboat, BMW and Bobber it's just been sitting, time to get back on it, mount the seat and start setting up the electrical.

After 2 years finally got it just about done but going to re-do the wire harness, the turn signals keep f'n up and just setting up on/off switch, start button and turn signal on tank console.

Top View

More Pics, new headlight just mounted, need new pictures.

Well finally progress again on the Bobber (more that brat/cafe, save cafe for the KZ550). buttoned it up, rebuilt the front caliper and painted, everything working and registered, got to ride it a couple miles, had to re-tune the carbs, too much popping, need to remove the AIS system. Decided to...

Getting close

Test fitted the seat, received the tail light and head light, need a dry sunny day and it should be on the road soon, have to grease the axle too and check all the torque settings.

Are you sure it's the carbs and not the throttle cable? they rust up. You may be able to just clean the float bowl, the gas evaps then leaves a sludge that if not cleaned out plugs up the jets passageways etc. At least try it first and new filter from tank so you don't get rust.

Welcome, did you start a build thread yet?

Sounds like fun, lucky my bike ran when I bought it, only rode it 5 mins then tore it apart. Had the wheels powder coated, came out great. Waiting on the header gaskets so I can fire it up. I am sorting the electrical now, building a new battery box under the seat horizontal since it's gel. have...

Great looking bikes! The brakes should do fine, just put modern pads and make sure its all up to snuff with the master and lines unless you're riding 2 up all the time. Would hate to lose the identity of the bike, it's pretty sweet.