Recent content by Steverino

Good luck....hoping for the best.

Even if more gas is sent...the needle valve closes and does not allow it into the bowl. If #2 is the only carb with a high gas float level....I think it is in that carb.

Did you swap the needle and seat? Or just the needle. I do not see how a blockage anywhere would cause this problem. Steve

Swap needle valve assembly with number 1 and see if it follows.

I have seen constant leaks caused by a cracked/split brass overflow tube inside the float bowl. (At least on 750's) Check this...or swap it with #1 bowl and see if it follows. Steve

Thanks for the suggestions guys....I will shop around....just looking for liability. Steve

Hi guys, Hoping you can help. When you are shopping around for insurance for your cafe they inevitably ask you, if it is an older bike, whether or not it is stock or had any modifications. Do you guys fess up and tell them the mods....Or just fly under the radar if they don't request pics...

Tomaselli clip ons 35 mm Basically new ....test fitted $150

HM36M headlight assembly. I assume the light works but will check before sale. Decent condition. 15/10 $25

Nice gauge set....you know what it is for....I don't. With wiring and bracket .... Some scuffs on plastic face that should buff out. $60 Lots more to come....stay tuned

One front brake lever with stop switch and two new cables for Suzuki GT750 with 4LS front brake drum $75

One set of new bar end turn signals $30

Here we have a set of OEM .50 over pistons and rings for early cb750's. No pins or clips. Rings are original style with one piece oil ring...same as came on sand casts and K0's $250 for all One set of four .25 over rings for cb750 $60 Check out the part numbers if you are not sure. One set of...

Hi, I'm starting to cull the collection and thought I would post up some items over the next little while. All prices are in Canadian funds. I prefer to sell local as shipping is so expensive ....and a pain in the ass. But..... I am in Nobleton....basically the greater Toronto area. If my...

So, it only took 6 years of collecting parts and sitting on my ass....and the 6 months of assembly and fabrication with the following results.