Recent content by Sunrise4567

Looks great, you will love the extra torque. How did you go about ordering direct from Skyteam? In the past I have tried to do this without luck as it is the obvious choice to cut out the middle man. Was it cheaper than 00 racing? If you could let us know how we to could order directly from...

Ok great, now I now what to look for. Do you need a special tool to compress the valve spring to get to the seal?

I understand that a small amount of ticking is correct, but it was when changing from the 125 to 150 that the ticking increased to more than just a little bit and after warming up is quite loud. After checking the valve clearances many times I had given up until now

Summer's here! The 'Ace' gets a bit hot when ridden for extended periods at full throttle (is there any other way?), so this will help… Is fitting one of these advisable for SE QLD weather? Has there been a problem with overheating in your area? Or is it just being proactive??

A question about replacement of the cush drive rubbers. Should any grease or lubricant be applied during replacement, or do you firmly drift them into the hubs dry? Any advice is greatly appreciated? Cheers Cameron

I have found the increase in performance to be just as crazy states, around the same percentage as the capacity increase. It makes a real difference in mid range torque where it was definately required. Top end gains where not as great in my experience, but my exhaust has the cat removed and a...

Good point, I did notice that there isn't much space around that front fender. I gave it all a bit of a flex outward to get a bit more clearance for the tyre Cheers

Hi, I Have a question for everyone running Michelin M45's. I Just bought some and noticed that they have arrows that point towards each other on the tyre for front and rear. Does this mean the front has the pattern with rounded arrow pointing towards the ground as we look at it from above and...

pic of the damaged cam gear....

Well I have had a bike shop split the crankcase for me an inspect and clean out any remaining metal fragments from the thrust washer that was eaten. Turns out the cam gear ate it and in so doing made some ugly looking scratches and slight bends to some of it's teeth, so a new one was ordered...

You make a lot of sense....will keep you up to date once I decide what I am going to do.

This is getting way past my level of knowledge. Should have stopped at jets and rear sprocket!!! I may have to take it to someone who knows what the they are doing for the rest of the job. Thanks so much for trying to help though...Even after reading through an old CG125 manual I just dont...

From the left side do you mean as you look at the bike from the front?