Recent content by supercafe

didn't get a pm?

i am in brockville canada, selling a 69 triumph, with tons of new and old parts. springer front end, 4 under. new tanks, new bars, controls, cables, etc.. new wiring, coils, exhaust, fenders, new carbs, etc..... motor needs a go through. any way it is a project, with every thing to get it...

sending pm on triumph parts.

a electronic ignition in my opinion should be in the budget of any build. just my 2 cents. its up to you but the starting and running of the bike will be night and day.

ya, the electronic ign is a replacement of the points. bolts right up easy to wire. its around 150 but is well worth the money. as for the filters, i would not run them. if the microns in the filter is not right, then you could starve the engine of fuel, etc.... run it straight, the pet cock has...

hello, i would be drainning the fuel out of the tank, and pet cock. to make sure that the tank has no rust, which is where the problem started. then pull the carbsand pull them apart, clean out the fuel tubes and gallaries. thats my two cents. also, if your bike dos'nt already have it, a...

nice, let us know how it turns out

man, thats some nice work and paint aswell. i am doing a triumph hardtail, and hope that it turns out as good as this. love the springer good call on that. have you had the shake down run with it, would love to heir how it rides. killer job man,

von, i have one that is untouched, not even painted, brand new. it is channeled for my t100 triumph, still has the oem brackets on it. also have a used one duel pet cock, needs to be creamed on the inside. i think it is a king sportster tank, larger. not sure which one i was going to use, but...

also it depends on where you are located. like in the states the prices of bikes are lower i find than here in canada. so that is some thing to consider aswell.

yes i agree, if it has a title it is worth abit more, and also with out a pic it is really hard to say. but i would have to say if it is your first bike??? or your looking to have it going and on the road for the next couple of months. then i would say don't buy a parts bike, spend alittle more...

hello, well i bought my cd175 for 600$. that was running, and just needed tires for saftey. after that the bike went under construction, engine frame etc... put about 2000 into it with out opening the engine, all together. then the cam chain went on it, and had to open it and cost me another...

very nice, love the look. wish it was in my garage. you did a out standing job on this bike. the powder work matches very well. good stuff my type of bike.

thanks man, let me know what the shipping is goning to be for the left side cover, also if you could see what it would be for the right and left aswell, if its no troouble. thanks again...

hello, i am located in brockville, just east of kingston. in ontario canada. what would you like for the cover? thanks.