Recent content by tacks

I've got one off a CL350, I am waiting to hear back from someone else on whether they want it but PM me your email if you would like me to send you pictures.

Front or rear? I've got a set off of my 71, got all the lights and stuff for it too, I believe. PM me your email and I can send pictures.

Ozfab, I didn't think of that. Gonna order a can now and will report results when I'm able.

Hi all, finally got my first bike (CL350k3) running and have a few small things I have to do to get her road ready, but since I live in Michigan, looks like that's not happening before winter. My question is this: I spilled gas on my tank (rattle can job w 6 layers of clear coat) and the clear...

Looks like a great project, looks like you could use new motor cover hardware, 4into1 has stainless complete sets that are awesome. As far as your valves go, if you can, I'd take them off, take a wire wheel to them, and hit them with some lapping compound before remounting them, it was worth the...

Turns out the lead up in the headlight bucket wasn't hired up to the positive lead, rookie mistake. She's running more, albeit I need to mess with a float.

Hi everyone, Unfortunately I had things other than my bike that needed attending to first so I haven't been able to work on it for a couple of months here, but the other day I cleared up my schedule, and ran into an issue. I rebuilt the top end of the motor, replacing piston rings and gaskets...

I need 2 cable tension adjusters for my CL350 build. What they're off of doesn't matter at this point, I just want her on the road before summer is over. The cables on the bike are 8mm so as long as the adjusters are the same size, I don't really care what they've come off of, I can make them...

Hi all, missing an obsolete part, can't find it anywhere on the internet even. Can't finish my build until I can get my hands on a clutch adjuster screw. CL350k3, Honda part number 22837286010. Please let me know if you have one or know where to find one. Located in metro Detroit.

If there's any chance you've got an extra blinker relay or a clutch cam adjuster, I'll take it/them. I just put up a post in the selling forum of parts I'm getting rid of if you're more into trading, but I think I'm getting rid of many of the same parts you are.

Hi all, I'm in need of a few small parts to get my bike on the road after a long build. I need a Blinker relay and a clutch adjuster cam. If you are interested in any trades, take a look at the buying forum, I'll be listing a bunch of parts I have extras of or have gone to aftermarket with.

Hello everyone, I've had a lot of great help from the community so far, hoping for a little bit more here. I'm going to flip my gauge mount to avoid the "frog eyes", but it's hitting the top triple tree without modification. In the future I'll be upgrading to smaller gauges but until then I'm...

I don't know why I didn't think of sanding/filing it down to begin with... I already bought the RTV but I'll try the fine sandpaper/file method first and resort to Loctite 518 if it doesn't seem to do the job. Thanks everyone.

I have almost completed my build of my '71 CL350K3, and am just hammering out controls, electrical and exhaust, and am getting ready to put my carbs together after rebuilding. The issue I am having is there is a small amount of bowing between the float bowls and carb bodies. I have the correct...

They may vary stock, but I double checked them, if 68 was standard in one, it was replaced by the previous owner with a 70, all jets match, but thanks for looking out.