Recent content by Uglyrabbit

Nice project. I’m jealous

Thank you Sent from my iPhone using DO THE TON

Anyone know if there is a fix for the iPhone? Sent from my iPhone using DO THE TON

That will look good! Sent from my iPhone using DO THE TON

That is why I have gone through the trouble of replacing the cast 19in front wheel with the 18in spoke wheel Sent from my iPhone using DO THE TON

Sent from my iPhone using DO THE TON

Painted and installed Sent from my iPhone using DO THE TON

Re: Building my own two-stroke "Mongrel" - Inspired by CharlieT & TedT Radical! Sent from my iPhone using DO THE TON

Mobius, I am confused by your question. My bike is a Xs500 not an RD350 so the forks are installed in the factory orientation. I know that the rim is wide I’ve made a few rookie mistakes with this bike but it is far from being complete. My intentions were to run Dunlop 100/80/18 front and...

I wanted to clean up the triple tree because I didn’t like the now exposed clamps. So I attempted to use and XS400J flat top triple but the spacing is off by 10mm. I may revisit this in the future as it will require the use of the bottom triple clamp, a new fork brace, possibly a new axle and...

F that! Build them all! Sent from my iPhone using DO THE TON

Mobius, Thanks for the reply. I tried to use a countersink tool on the front rim to no avail. But after reading your post I'll have to try it again, I tried to do it without the rim laced so I'll try your method Sent from my iPhone using DO THE TON

After looking at a few picks of other wheels with MikesXS rims I think the problem may be the spoke length. I think the spokes are too long changing the angle at which they exit the hole. Sent from my iPhone using DO THE TON

Nice! Sent from my iPhone using DO THE TON

Thanks I'll have to give them a call Sent from my iPhone using DO THE TON