Recent content by WhiteRabbitt

thanks for the responses. I did not know about the heat activated sealant, thanks for the heads up. and I have been too afraid of causing damage to the sealing surfaces to try separating them that way, but the razor blade and heat ideas I will give a go. thanks again, and may I add that this...

got two of them. just pulled my 350 f apart to part out soo..... robelston@yahoo.com

I have totally disassembled my 350 four engine but I cant get the cylinder block off the top case half. I have tried softening the gasket with penetrating oil from inside and out, tried knocking it loose with the rubber mallet, and tried driving it out with an aluminum bar on the bottom of the...

thanks I thought there might be a cheap way to go about it. i didnt include bike info cause its a pretty universal question, but: its the 72 cb 350f I have listed in the sale area for parts. I ask this because if nobody wants the parts I am going to revive it, as this pretty little engine is...

is there a way to restore or otherwise make useable carb holders that are stiff from weather and age? the carbs were a pain to remove and just will not go back on without more force than I am comfortable applying to the carbs.

I have a 72 cb350f I want to part out if there is interest. I got the bike without title or bodywork. whats for sale: forks, triples, wheels, seatpan and engine, plus a few misc bits like a tach, the lighted riser clamp thing, a couple of front turn signals, motor mounts, etc.. the engine...

I have a 72 cb350f I want to part out if there is interest. I got the bike without title or bodywork. whats for sale: forks, triples, wheels, seatpan and engine, plus a few misc bits like a tach, the lighted riser clamp thing, a couple of front turn signals, motor mounts, etc.. the engine...