Search results

I'm posting here partly because I'm not sure where else to go... Does anyone out there have a c200 and know these bikes really well? There are a few distinct differences between my (1965) c200 and every other c200 I've ever come across. I need to locate a horn badge and speedometer for the...

I'm working on starting a 360 after a top-end rebuild and new wiring harness (and ground-up build in general). When I turn the bike over using leads to a 12v car battery, the wires in the loom that connect to the battery (via leads) get extremely hot after a few rotations. The loom has a...

I'm setting up a Pamco electronic ignition for a cb360 and have run into an issue that I just can't seem to account for (with no luck searching DTT / elsewhere): According to The instructions, the included rotor should be a direct-swap using the original hardware (just a bolt w/ washer into the...

Alright - sorry if this has been covered, but I can't seem to find any info... I plan to powder coat my hubs this week, and have not yet removed the sprocket stud bushings. A few questions: 1. If I don't remove them (they're in good shape) will they take the heat of the oven when baking the...

Alright, here goes: I'm a newbie when it comes to bikes, but when I do something, I usually dive right in (and sometimes find I'm in over my head!) I picked this bike up a month ago. It's a '75 CB360, which was in running order when I purchased it (I rode it home 40 miles): My plan is to go...