Search results

hi its me for the 20th time. This time once again I am rebuilding my valve mechanisms. does anyone know of an informative good cl350 valve mechanism video on youtube because I am at a loss and i did a few things wrong last time so help would be great. thanks

my CL350 1972 has power but it doesn't want to go to the coils I have made sure the condenser is grounded, i have power going into the condensers and coils but no power coming out. Also whenever i plug the blue point wire into the harness it shorts or something and blows my fuse every time...

I was wondering if anyone had some 1972 350 Honda connecting bullets? These are the last things that I need to finish building my wiring harness. The eight bullets are the ones that have a longer shaft i included a picture the red circle has the extended bullets that i need. or if you have a...

I am not saying these are any good or just saying im bored and looking at cl for semi complete bikes for under 500 and some of these are parts bikes apparently so whatever :/ just thought id share. http://merced.craigslist.org/mcy/4904725661.html Vintage 1974 Yamaha RT1 360cc BARN FIND...

i was putting my engine together and i accidentally over torqued my bolt holding onto the points side of the camshaft. I was hoping someone out there has a camshaft for my CL350 1972 or is it possible to repair it? It was in near perfect shaped until the piece broke off last night. I have...

so i know i left two parts out of my engine and was wondering where they went since im pretty sure honda didn't throw random parts into the bike to confuse people any help would be great these two parts are from a 1972 cl350 again any help would be great. I have turned over the engine or...

cl350 .25mm oversized piston rings thought that wear would cause my pistons to be worn a lot more turned out my motor has less than 1000 miles on it as the engine was swapped. any body want cl350 .25 oversized piston rings pay the shipping and what ever you want and they are yours. one package...

hello first time bike builder here and i am a low income college student and i was wondering since i am almost done rebuilding my 1972 CL350. I was hoping to use a Honda 1968-1978 CB750 camchain tensioner like the set in this one in place of the three times as expensive set from cmsnl.com has...