Search results

Hi guys! I'm doing my very first build, and almost everything is new to me, so I naturally need a little help once in a while. It's a Honda CB 400 F from 77. I have decided to go with a M-Unit V2 and also bought a combined regulator and rectifier. I'm currently drawing the new wire diagram...

Hi guys! My Cb 400 F engine is apart, and I have used plastigage on all 5 bearings, and they are within specification (I have misplaced the paper where i wrote it on, so maybe ill do another check, but i definitely remember that they where all within spec.) On my crankcase its say BBBCC, but...

Hi guys! I'm doing my CB 400 F rebuild. I'm painting the engine with VHT Aluminium paint, and I'm curing it in the oven. But how about my head and the valve stem seals? How much heat can they handle? Obviously they must be able to handle working temperature of the heads, so I could just cure...

Hi guys! So I want make my hubs good looking before assembling. I want to paint the entire front hub with VHT aluminium paint and the rear I will polish on the side, and in between I will paint it with the VHT. I have sanded and cleaned with WD-40 and a brush for many hours now, and even soda...

Hi guys! I'm currently in the early stages on restoring and changing my first older bike, a Honda CB 400 F from 77. I've got the original 7/8 inch handlebar and want to keep that, but would like to get rid of the handle bar switch. My question goes, which push/pull throttle can I buy, that...