Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
Def running rich! I'll drop the mains to 110's and see what happens but you'd recommend putting the needle clip back up would you even though its rich? It was at second notch from the top and was still making the sound so there's only one more notch to move before it's at the top.
Doesn't feel...
Thanks for your reply. It's a Mac 4 into 1 with a shorty reverse cone muffler. The Pods aren't EMGO, but could be pretty similar in terms of crap quality. When I ordered them they were a fairly expensive pod and I thought they were K&N, but after they arrived they said Taiwan on them. I later...
Hey everyone, apologies up front if this is not posted in the proper area. I'm having an exhaust stutter at cruising speed around 1/4 throttle in all gears. As soon as I roll past this a little ways it goes away, but returns when you come off the throttle. Basically you can't hold a cruising...
Thanks for all the helpful suggestions. I decided to go with dremeling out the switches. I figured there would be less margin for error than drilling the clip-ons which were quite pricey to begin with. I sourced some replacement switches just in case everything went to hell and I had to buy new...
I've been spending a bit of time looking around since I started this conversation and I've started to notice some people with the 550 choosing to drill the bar and have their wire bundle run through the clip on and out the end. I wasn't sure I'd like the look of this, but I suppose it's an...
Hey there, so I have a set of clips on bars I'd like to install on my 74' CB550. Currently the stock controls on the bars have their wires threaded through the stock bars. Rather than drilling holes in the clips-on and having the wires threaded through them, I'm curious what people are doing as...
Nice work so far!
Quick question regarding your clips ons and your handle bar controls. I recently bought some clips ons for my cb550, but I discovered the other day when I was went to install them that the stock controls are threaded through the stock bars. The wires extend through the centre...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.