Search results

Hi guys, I am having a little trouble with my "clutch actuator". I found a good tutorial online and did everything just like it said, but when I drop it into first gear out of neutral it stalls out before I even release my left hand lever. It is also making a clicking sound when I pull the...

Bump...

Re: Clutch actuator issue... Right that would help... it's a cb350

Hi guys, I am having a little trouble with my "clutch actuator". I found a good tutorial online and did everything just like it said, but when I drop it into first gear out of neutral it stalls out before I even release my left hand lever. It is also making a clicking sound when I pull the...

Hi all! So I have a CB 350 and I wanted to take a friend for a ride the other day,but with the both of us on my bike the seat basically touches the back tire...I weigh 180lbs and my friend weighs less than that. Is there something you need to do to the shocks if you have a passenger on these...

Great help guys thanks!!

To julian.allard66: I think you are right, but I have no way to compare it to the correct part even if you did measure it, as they don't have measurements on line of my part and I don't have one to measure... To VonYinzer: Thanks I reposted there!

I am not looking for a ball bearing... it's 3 ball bearings in a flat meta disk. The original image of the part in my first post is from the link you just posted...they don't have this part in stock.

How would they find this part? I am pretty sure it's not made anymore...?

Noticed this guy is missing in my clutch set up! Anybody have one? Thanks!!

I think I solved it. So I had the "L" turn signal in the handlebar wired to the "Light" on the M-Button. This was causing the M-Unit to humm the tone recorded above ever time I plugged in the wire to the m-unit. Now I am trying to rewire the "High Low Beam" switch on my handlebars. I have three...

Ok! did that and found the problem to be in the wiring of my high low beam switch to the M-Button! Ok so I think this switch isn't grounded properly. I have three wires coming out of it, Baby blue (at bottom)/Brown w/ White stripe (at middle) and solid White (at top). I guess I'm a little...

I had the M-unit working but now just the "lock in" and "Aux out" are lit up. Really confused and would appreciate a little guidance if anybody is feeling helpful. Thanks!

Hey guys realized this might be a better thread to post this on.... Here is the link to the question. Just looking for thoughts on a fix! Thanks! http://www.dotheton.com/forum/index.php?topic=73958.msg877346#msg877346

I thought I would note also the headlight bulb is humming at the same frequency sound as the M-Unit?!! Any Ideas?

Ok so I took the wire coming from the headlight to "Light Lo" on the output side of the m-unit and it stopped! What does that mean? A bad ground from the headlight maybe? Thanks!

If I remove one wire at a time is there any damage that could be done? I figured this might help me rule out the problem?

It's mounted to a small box under my seat and that noise is for sure coming from the M-Unit. I did what the guys at A&J said and the buzzing stopped, but as soon as I plugged the wiring back in it started doing it again. It seems to do it after I turn it off. ("This is the first I have ever...

Moto Gadget was zero help, they just said they have never heard of anything like that happening and that there is nothing in the M-unit that can make a sound. And yet I have a sound clip attached to this very thread.... I am going to try what A & J cycles recommended "This is the first I have...

I got it from A & J Cycles. good call, I sent messages to them and Moto.