Search results

Hi all I am looking for a seat loop for my sr250. Firstly what is the size of steel tube I need to match existing frame once welded on and does anyone have any good shape options I should consider bar your typical loop? Thanks very much, Jonathan Sent from my PRA-LX1 using DO THE TON mobile app

Hi all I have have a couple is small pieces sandblasted a couple of weeks ago. I have kept them wrapped in a dry micro fibre cloth in a dry place however I think from initial contact with them they have developed very slightly rust spots. The question; Can I use a metal, grey primer rattle...

I am looking for a good vapour blaster or vapour blasting service in or near Hertfordshire, UK. I want to go this route on entire engine as will be the less abrasive method is that is right? Also, if the original metal has a polished finish but is now darkened and tarnished will the vapour...

Hi All I have made the rookie mistake (which will never be replicated) of breaking one of my engine wings. it is a clean break and if there is an appropriate method of sticking it back on it will go un-noticed! Whats is the best method in doing so please? I have attached pictures :)...

Hi Guys Looking for a recommendation for a good electrician to re-wire entire bike in and round the Hertfordshire area preferably. Cheers

Hi Guys I have a dent in my sr250 tank. I am unsure whether to keep the patina as is and seal or get sprayed.... I will however require dent out. Is it possible for this to be pulled out or will it have to be filled or similar? From what I can see the rest of it seems pretty straight...

Hello all Just joined the forum and looking forward to networking with you all over the process of my build and yours!! First one so abit of a novice but going well so far... i think... Would welcome any suggestions for any suitable rear shocks that won't break the bank and perhaps front and...