Search results

I am having an issue with my CB750. One cylinder is always about 50 degrees Fahrenheit cooler than the others. I have swapped plug leads around, checked float heights, cleaned carbs and checked shim clearances and all is OK. It idles smooth and revs OK. Anyone any thoughts? Would I need to...

I have fitted a GSXR 750 rear master cylinder to my CognitoMoto CB750K rearsets but I am a bit stumped as to how/where to put the brake light switch. Anyone have a similar setup and like to share some pictures?

I am looking to find a gear change arm that will fit the gear change shaft on a SOHC K7. I have fitted custom rear sets. The part I am looking for is similar to this: (the piece with the splines)...

Hi all, I have come up against a bit of a wall on my CB750 project - http://www.dotheton.com/forum/index.php?topic=75591.0 When I bought the bike the bike had, what I am 99% sure, were Bandit 600 carbs. The previous owner had made some custom intake manifolds too which are really well made...

I hope to fit a set of KZ1000 P wheels to a cafe racer build I am working on ( http://www.dotheton.com/forum/index.php?topic=75591.0). The wheels are on the way to me but do not have rotors. The current GPZ900 rotors are 280mm outer diameter and 130mm inner diameter with 6 bolts. The KZ1000 P...

Does anyone know if an 18" wheel off a GPZ750 will fit onto forks of a GPZ900 fitted with a 16" front wheel? I would prefer an 18" for the Cafe look I am going for. Current wheel: Wheel I would like to use...

Looking for a set of Mag wheels to fit a 1977 CB750K7. Front and rear. Would love Lesters but open to alternatives. PM me if you have anything on offer.

Hi All, Long time browser of the forum but this is my first post. I have to say to all, some of the bikes showcased on this forum are amazing. Great inspiration. I picked up this bike earlier in the week. The engine is seized due to sitting up but as you can see someone had started to do some...