Search results

Thought I'd share this on this forum as well - Thought I’d share some links for my setup to create a carb sync kit. Have had a hard time finding all the pieces - everything I purchased to sync the carbs is below! Carb brass fittings 6mm x .75 (if the link ever expires, search eBay for “6mm x...

Been thinking about getting my rotor resurfaced and holes drilled for years now. Finally decided to pull the trigger. What an incredible experience! You simply pack it up, ship it over and a few days later you get a PayPal invoice and it get's shipped back. You can pick pretty much any hole...

I’ve been posting here on this forum for quite some time now - I am a Honda CB360 owner/builder and such. Before my last rebuild, I wanted to get my cylinder head machined, bored and cleaned so I took it over to Valley Cycles in Los Angeles, CA. I spoke to the shop owner Kurt and his son Dylan...

Thought I'd share! Made a cool video time lapse showing the teardown on my Honda CB360 - currently at the machine shop getting .5mm bored, and having the head cleaned/valve job done! Going to do a part 2 when I reassemble all fresh and clean! Hopefully all this takes care of the oil blow by I...

1974 CB360 - finding gas on the right side spark plug. Left side looks clean. Bike starts first try every time, idles, I can drive, it has power throughout all the gears, no bogging or anything, literally runs perfect. After warming up, I am getting a light amount of white smoke from the...

I have a set of 7/8’s clip-ons that fit a CB360 or 33mm fork and an 18” long baffle with a 2.583 O.D. - I got a pair of them on eBay (used from some Kawasaki) and only needed one to fit inside my shorty 12” cone engineering exhaust- (exhaust not included but shown as an example) Just pay...

Hey all, Been looking for a set of adjustable clip-ons for my 1974 Honda CB360. I've done so much research but never seem to find a simple set that was adjustable for the angle. Everything I could find cost an insane amount or you had to buy additional plates to adjust the angle of them. Well I...

Hey all, I have a 1974 CB360 and when I bought it, it had a master cylinder from what I believe is a goldwing. I recently replaced the caliper assembly along with a new stainless steel brake line. After hours of bleeding and running a 12oz bottle of fluid through, the brakes still felt soft and...

1974 CB360 - The other day on my way home, I noticed I lost all my top-end power, then after looking down, I saw oil spewing out of the valve cover and light blue smoke pouring out of the exhaust. After pulling over, I noticed the rock rocker arm shaft must have backed itself out on the...

Does anyone know a place that will drill holes in my rotor in Los Angeles? I would do it but only have hand drills and don't want it to get sloppy, if I had a press...different story ha. I did find truedisk.net and may go that route but would prefer to avoid shipping back and forth and downtime...

Hey everyone, I have a ton of miscellaneous engine parts and a few extra pieces from my build that I don't need. Open for offers on everything, no set prices. I get a discount through UPS so I can quote you shipping prices before we agree on anything. Please PM me your address information to do...

Hello all, first post and thought I'd share my latest project. Picked up a 1974 CB360 halfway cafed and just about finished it off. Engine and carbs just rebuilt and freshly painted. Still some small things to do but here are the pictures below with a list of mods. I thought it would be good to...